Please make certain that the correct, approved guard for the cutting attachment is installed. For the correct guard and proper installation, please consult the Instruction Manual.
Step 1 of 5: Preparing your brushcutter
Please make certain that the correct, approved guard for the cutting attachment is installed. Hold the brushcutter with the mount for the cutting attachment facing upward.
Step 2 of 5: Locking the shaft
Push the locking pin or the offset screwdriver into the hole in the gearbox. Now turn the shaft until the locking pin engages and locks the shaft in position.
Step 3 of 5: Fitting the mowing head
Turn the mowing head anti-clockwise until it reaches the stop on the shaft.
Step 4 of 5: Tightening up the mowing head
With the shaft immobilized, tighten up the mowing head.
Step 5 of 5: Removing the tool
Then remove the shaft-locking tool again.